This boat is a Lonestar, titled as an unknown year but was built in the 1960s. It has a riveted aluminum hull. Hull is in good shape (watertight, no large dents, looks good). I completely renovated this boat. It has pressure treated ¾ inch plywood decking covered with vinyl boat flooring. Interior was painted with zolotone. I re-wired using marine wire on running lights, stern (anchor) light, bilge pump all on a switch panel. Boat comes with an older fish finder (works fine). All fasteners are stainless steel. Boat has two padded seats with backs. Storage under the seats and there’s a hatch at the bow. Foam flotation in the bow and forward of the two seats. Comes with two rod holders and three mounts. Motor is a 1977 30hp two-stroke Johnson. Tom’s Outboard installed a starter about 3 yrs ago and compression tested it. I recently put a new solenoid on it. This motor starts right up and runs great. Trailer is painted, new trailer lights (trailer lights also mounted on the boat itself) with straight 4-prong connector. Trailer has tandem axle, new bearings and bearing buddies. It also has new 2x6 bunks covered in carpet with high-density plastic pads for easy loading. Also has a new winch and heavy strap. New tires, including spare. I’ve fished this boat on the Columbia (calm areas only) and Willamette Rivers and also for lake fishing. It back trolls beautifully. For more info call Cyndi (503) 568-9279 Location: Oregon City or Warm Springs it's NOT ok to contact this poster with services or other commercial interests oregon