1994 200 Johnson Venom Outboard. 20'' short shaft. Like all v6 outboards, this one has power tilt/trim. It has been completely rebuilt by a certified master OMC tech with less than 12 hrs on it . The rebuild list is long, but the important new parts/service include: 6 NEW OMC FACTORY PISTONS .20'' OVERSIZE REBUILT CARBS TIMING SET HEADS AND ALL MATING SURFACES BROUGHT BACK TO SPEC WITH NEW GASKETS NEW THERMOSTATS ALL NEW ELECTRONICS (POWER PACK, COILS, STATOR ECT..) RE-SEALED LOWER UNIT WITH NEW BEARING CARRIERS i am probably forgetting some stuff but i have the receips and the tech's phone # if you have any doubts about the rebuild. Nedless to say it has perfect even compression and starts with the first turn of the key (even when cold). Now for some FAQ's that you might have: Q: Does it come with controls? A: Yes it does. The OMC control box is practically brand new as are the shift cables. It also comes with a 6'' manual jackplate and transom washer. in the dash there is a brand new OMC speedo that just needs to be hooked up. I had a tach in it when it was in use but i robbed it for another boat that i use in saltwater. It has dual cable steering with all new connector parts (old ones were robbed for my other boat , again) . Q: What boat is it on? A: The boat is a 17' Baja sport from 1983. It is a closed bow sportboat with a solid transom and i redid the floor 3 years ago. I have hardly used the boat and motor sine i got it. I used it in saltwater for 1 week and flushed the motor after each use. I hate leaving the boat and motor in saltwater so i just trailered it the whole week. It was properly winterized and i just fired it up with fresh gas this week. It uses a 50:1 oil ratio for increased reliability (VRO was removed). The boat looks a little rough and needs cosmetics (dull gelcoat and lots of scratches but hey its free and solid). the seats are in good shape but need to be anchored down properly. Q: Why are you selling it: A: I simply dont use it enough and have too many projects right now. Also the economy is killing me and i need the money. I will not go any lower than $2999, however as i paid 4k (have receipts) for the motor alone (without controls or prop) and $1500 for the boat (it had a bad floor so i had to redo it as well). Boat is ready to go as is and when it had a 26'' viper prop i had her in the low 70MPH range on GPS. Any more questions please email me. Boat is located in Charlstown, RI. Thanks and feel free to come look at it any time. Ill be happy to separate motor and boat. Location: CHARLESTOWN, RI it's NOT ok to contact this poster with services or other commercial interests rhodeisland
200 johnson evinrude ourboard motor engine  boat

Search Classifieds:




boat

Results for "boat "
Also see results for: boat 200 johnson evinrude
$50.00 (0 Bid)
Ending in: 21m
$50.00 (0 Bid)
Ending in: 23m
$36.99 (6 Bids)
Ending in: 30m
$0.99 (0 Bid)
Ending in: 31m