Stainless Steel Mercury Marine Mirage Model # 48-18278 17P Stainless Prop. It is 15 1/2 inches diameter, 17Pitch, right hand rotation. I had it on a 2000 Mercury Optimax 135HP. Excellent shape. Very minor dings on the leading edge. Just file them off. New price is $490. The Mirage 3-blade Stainless Steel propeller dominates High-Horsepower Boating with its large diameter and high output blade geometry. From V-6 Outboard offshore fishing boats to Bravo I Sterndrive vee-bottom sport boats, cruisers and race boats, the Mirage does it all.Asking $250 OBO. 230-9798 Location: East Anchorageits NOT ok to contact this poster with services or other commercial interests

18FT Air Cataraft W/Trailer. As you can see in the pictures there has been alought of work done to the frame to make it handle up to a 50 hp outboard. It has a 1/2\" Fiberglass floor and front deck, it has an 1/8\" white plastic scatter shield under the frame to stop water from spalshing up above the floor and more scatter shield around the motor to keep water under the boat and everything is held together with stainless steel bolts. It also has a heavy duty transum with an expensive motor adjuster to be able to move the motor higher or lower depending on its size. Even though it has all of the extras it is not heavy. It comes with 4 swivel seats, and two 9\"owrs. I used it to dipnet at the Kenai with 4 people on it and a 50hp yamaha and all the gear and it had no problems. The tubes will cary over two thousand pounds of people and gear. To get this built by the cataraft store it would cost alought more than I am asking. I dought if this will last long so call Rick at 350-3998 or 333-8378. Location: {{{{{ East Anchorage}}}}}its NOT ok to contact this poster with services or other commercial interests

Project Boat. Uniflite 23 foot Cabin Cruiser. Twin 120 hp OMC Inboard/Outboards. Heavy Duty Twin Axle Trailer with Spare tire. Enclosed Head (Bathroom). Galley with Sink, Icebox and cabinets. V-Berth with Dinette that folds down. Very solid Uniflite Hull. Motors need rebuilding, one removed, one in boat. Needs some cosmetic work in cabin. Rear deck removed, needs replacing. Complete, just needs lots of work. $3000. Phone Doug 333-3033 leave message if no answer, or email coho5@acsalaska.net Location: East Anchorageits NOT ok to contact this poster with services or other commercial interests

Great 18FT Air Cataraft W/Trailer. As you can see in the pictures there has been alought of work done to the frame to make it handle up to a 50 hp outboard. It has a 1/2\" Fiberglass floor and front deck, it has an 1/8\" white plastic scatter shield under the frame to stop water from spalshing up above the floor and more scatter shield around the motor to keep water under the boat and everything is held together with stainless steel bolts. It also has a heavy duty transum with an expensive motor adjuster to be able to move the motor higher or lower depending on its size. Even though it has all of the extras it is not heavy. It comes with 4 swivel seats, and two 9\"owrs. I used it to dipnet at the Kenai with 4 people on it and a 50hp yamaha and all the gear and it had no problems. The tubes will cary over two thousand pounds of people and gear. To get this built by the cataraft store it would cost alought more than I am asking. I dought if this will last long so call Rick at 350-3998 or 333-8378. Location: (((( East Anchorage))))its NOT ok to contact this poster with services or other commercial interests

Two Volvo 15X17 deep hub props with 17 splines. Fit Volvo 270, 280, and 290 outdrives. New, never used. $50 each . 337-2073 Location: East Anchorageits NOT ok to contact this poster with services or other commercial interests

18ft jon boat with 25 h/p mariner outboard. jon boat is a little rougf but well balance fishing boat in rivers or lakes. ther i s no trailer ,gas tank or gas hose . 441-8582 or 338-5360 Location: East anchorageits NOT ok to contact this poster with services or other commercial interests

1998 Honda 8HP long shaft four stroke engine in excellent condition. Runsgreat, used as a kicker, seldom used. With tank and hose. $1195 . Location: East Anchorageits NOT ok to contact this poster with services or other commercial interests

This is a seat built to strap in on the floor of a canoe or in a small boat. Its designed to put the back against a thwart bar, or cooler, etc. to be able to get some good back support (nice in a canoe or little boat). Its new, never been used, just been sitting in the garage for the past 10 years. 14\" wide, 12\" deep, 16\" high.Email works very well, or call 230-1081.$20.00 OBO Location: East Anchorageits NOT ok to contact this poster with services or other commercial interests

I have a set of Mercury Mirage plus Stainless Steel props with universal hubs. A hub is required based on your application to mount on your outdrive. They are like new, but have been used. No nicks or dings. Part numbers 4818281 and 4818280. I have the hubs for OMC Cobra and Volvo applications. $200 for the pair. I also have two aluminum 4 bladed Mercury props(14.5X18), also universal mount and like new , both for $100.00. .337-2073 Location: East Anchorageits NOT ok to contact this poster with services or other commercial interests

I have two Michigan Rapture Stainless Steel propellors for sale, one standard rotation(Left) and one right rotation. Part numbers 163022 and 163023. Fit OMC Cobra, or Volvo SX outdrives. Matched set, 14in 25 pitch, 19 spline , no nicks or flaws, lightly used. List $359 each, both for $150.00. 337-2073 Location: East Anchorageits NOT ok to contact this poster with services or other commercial interests

Four Volvo 15X17 props with 17 splines. Three deep hubs and one standard hub. Two left rotation and two right rotation. Fit Volvo 270, 280, and 290 outdrives. New, never used. $75 each or offer. Left hand props sold. 337-2073 Location: East Anchorageits NOT ok to contact this poster with services or other commercial interests

16, klamath stolen from my front yard 5/12/09. Please call 337-8684 or APD @786-8801 Case # 09-23188. Reward for information leading to the recovery of my boat. Location: EAST ANCHORAGEits NOT ok to contact this poster with services or other commercial interests

I have four Mercruiser props in excellent condition. All four are 15x17, 19 spline , but two are left rotation and two are right rotation. Part numbers are 3855480 for the left turn props and 3850300 for the right turn props. No nicks or dings on any of them. $75.00 each. Grreat opportunity to get a replacement or spare prop at 1/3 price. 337-2073 Location: East Anchorageits NOT ok to contact this poster with services or other commercial interests

Very nice 15HP Honda long shaft 4 stroke. Only used as kicker, little use. Mid 90s vintage. $1395.00 337-2073 Location: East Anchorageits NOT ok to contact this poster with services or other commercial interests

16 Klamath STOLEN from my front yard Tuesday morning 5/12/09. Boat was on brown over sized trailer, 14\" nokia all season car tires on new gray colored rims, (not the rims in photos). Was taken from Boniface/Glenn Hwy area. $300.00 Reward for information leading to the recovery of my boat. Please call 337-8684 or APD case# 09-23188. Location: East Anchorageits NOT ok to contact this poster with services or other commercial interests